Tower Busters
You’ll find here all the steps I go through to make Tower Busters.
IMPORTANT: I am not wearing any protecting mask on these videos while working with the resin just for practical reasons, the sound volume is already very low, so, were I to wear a mask, no one would understand anything from what I’m saying (I’m talking in french). It’s not very bad to work with resin without an air mask once in a while, however if you are very often in contact with non-cured synthetic resin it is highly recommended to wear a protection mask because resin vapours are toxic before the resin has hardened. I wear a mask (which I usually wear all the time) during the sanding step, you can see it at 20sec on this video.
1. Manufacturing of round TBs (pouring)
2. Manufacturing of round TBs (demoulding)
3. Manufacturing of round TBs (sanding)
4. Manufacturing of round TBs (dusting)
1. Manufacturing of heart TBs (pouring)
2. Manufacturing of heart TBs (demoulding)
3. Manufacturing of heart TBs (sanding)
4. Manufacturing of heart TBs (dusting)
It’s exactly the same as for round TBs.