Cloudbuster

You’ll find here all the steps I go through to make a Cloudbuster.

IMPORTANT: I am not wearing any protecting mask on these videos while working with the resin just for practical reasons, the sound volume is already very low, so, were I to wear a mask, no one would understand anything from what I’m saying (I’m talking in french). It’s not very bad to work with resin without an air mask once in a while, however if you are very often in contact with non-cured synthetic resin it is highly recommended to wear a protection mask because resin vapours are toxic before the resin has hardened. I wear a mask (which I usually wear all the time) during the sanding step, you can see it at 20sec on this video: Tower Busters > Manufacturing of round TBs (sanding).

Manufacturing of Cloudbusters (Discs, tracing 1/4)

Manufacturing of Cloudbusters (Discs, cutting 2/4)

Manufacturing of Cloudbusters (Discs, drilling 3/4)

Manufacturing of Cloudbusters (Discs, finish 4/4)

Manufacturing of a complete Cloudbuster with copper pipes 1/3 (Preparing the tubes)

Manufacturing of a complete Cloudbuster with copper pipes 2/3 (Pouring orgonite, assembly)

Manufacturing of a complete Cloudbuster with copper pipes 3/3 (Demoulding)

Manufacturing of a complete Cloudbuster with aluminium pipes 1/2 (Pouring, assembly)

Manufacturing of a complete Cloudbuster with aluminium pipes 2/2 (Assembly end)